Sandblast Cabinet -- Carson Cabinet

From Artisan's Asylum

Jump to: navigation, search
Tools at the Asylum
Sandblast Cabinet

No image. This tool needs an image.

General Info
MakeHarbor Freight (Central Pneumatic line)
Model68893
SerialUnknown
Mfr. Specs
ManualManual
Training (experimental section)
Tool SpeciesSandblast Cabinets
(Includes rubric, training information, and testing information.)
Asylum Info
LocationWelding
Reservations
OwnerPaul Carson
Operational Status
Latest Status
?'s/Problems
QR Code



This page describes the Sandblast Cabinet located in the Welding Craft Area. It is owned by Paul Carson, and has been customized so that it will fit an entire bicycle frame inside it.


Contents

Usage

For general usage instructions, see the Sandblast Cabinets page.

Preparing for Use

  1. First, check its state -- not everyone leaves tools in good condition:
    1. Check the STATUS section of this page and look for any signs on the cabinet.
    2. Drain any water that is left in the water separator near the air inlet.
    3. Check that the sandblasting gun is connected compressed air.
  2. Set the air pressure regulator to about 100 psi, never more than 125psi.
  3. Load your parts into the cabinet through the side door.
  4. Plug in the light.
  5. Be SURE to follow the Shutdown procedure below when you are done.


Shutdown

When you are done with the sandblaster, please leave it ready for the next user:

  1. Unplug the light.
  2. Drain any water from the water separator on the air line.
  3. Turn the air pressure regulator down to 0
  4. Disconnect the compressed air line and electricity, restore them to where they belong.
  5. Clean up any abrasive dust which may have found it's way out of the cabinet and onto the floor or surrounding area.


Maintenance and Consumables

Maximum input pressure is 125 psi.

Staple Consumable: Sand
SpecificationsPart Number(s)Product Link(s)

Cost: N/A

?

Personal tools
Wiki Maintenance