3D Printer Bambu P1P: Difference between revisions
From Artisans Asylum Wiki
No edit summary |
No edit summary |
||
(3 intermediate revisions by the same user not shown) | |||
Line 21: | Line 21: | ||
}} | }} | ||
=Safety= | |||
Link to: [https://wiki.artisansasylum.com/wiki/Category:3D_Printers_-_Extrusion#Safety Safety notes for all FDM printers] | Link to: [https://wiki.artisansasylum.com/wiki/Category:3D_Printers_-_Extrusion#Safety Safety notes for all FDM printers] | ||
=Description= | |||
[https://wiki.bambulab.com/en/software/bambu-studio/studio-quick-start| '''Online Setup Guide'''] | [https://wiki.bambulab.com/en/software/bambu-studio/studio-quick-start| '''Online Setup Guide'''] | ||
==Mechanical== | |||
'''Stage:''' 200mm x 200mm; Z-motion; 3 jack screws; probably 1 motor. | |||
'''Gantry:''' Sliders on rods; X/Y "H-pattern" belt | |||
'''Extruder:''' 1.75 mm; Enclosed; no proximity sensor |
Latest revision as of 18:59, 31 March 2024
Link to: Digifab Shop main page
Bambu P1P | |
---|---|
General Info | |
Make | BambuLabs |
Model | P1P |
Serial | Unknown |
Specs | |
Manual | Online manual |
Asylum Info | |
Location | Digifab Shop |
Rubric | |
Training | |
Testing | |
Restrictions | red |
See the FDM category page for notes on using all extrusion-type 3D printers
Safety
Link to: Safety notes for all FDM printers
Description
Mechanical
Stage: 200mm x 200mm; Z-motion; 3 jack screws; probably 1 motor.
Gantry: Sliders on rods; X/Y "H-pattern" belt
Extruder: 1.75 mm; Enclosed; no proximity sensor