Category:Plasma Shop
From Artisans Asylum Wiki
| CNC Plasma Cutter | |
|---|---|
| CNC Plasma Cutter | |
| Lead | Sam Feine |
| Tool Testers |
Jim Bredt |
| Hours | Same as membership hours |
There is only one tool in this shop.
Torchmate CNC Plasma Cutter
Description
The tool consists of a CNC gantry with a 48"x96" table that carries a Hypertherm "PowerMax85" plasma torch. Cuts are made vertically over a water tank.
This is a RED tool! Users must be trained and toll-tested before they are permitted to operate it.
Materials qualified for general use are: Mild Steel, Stainless Steel, and Aluminum. Other materials that have been successfully tested are: Titanium and Brass.
Driver software is called "Torchmate 4" located on the attached computer with several installations around the Asylum.
This category currently contains no pages or media.
