Powermatic 201 22-inch Surface Planer: Difference between revisions

From Artisans Asylum Wiki
No edit summary
No edit summary
Line 106: Line 106:
|}
|}


''To interpret the results of test cuts, see pp. 16-21 of the [https://drive.google.com/file/d/10a8E4nqSp_wNh7Qiumm5EDxHJQdeAiWw/view?usp=drive_link Planer User Manual.]
''To interpret the results of test cuts, see pp. 16-21 of the [https://drive.google.com/file/d/10a8E4nqSp_wNh7Qiumm5EDxHJQdeAiWw/view?usp=drive_link 201 Planer User Manual.]

Revision as of 19:36, 17 February 2024



The Beast
Feeding The Beast
General Info
Make Powermatic
Model 201
Serial Unknown
Specs
Manual 201 Planer User Manual
Asylum Info
Location Wood Shop
Rubric
Training
Testing
Restrictions red


This is a RED tool. Training and tool-testing are required.

Warning Safety glasses Eye protection required!


Use For

  • Hardwood Boards
  • Lengthwise grain
  • Length > 10 inches
  • Thickness > 3/8"

Do Not Use For

  • Pine or Fir or other pitchy wood
  • Construction or reclaimed lumber
  • Stuff with nails in it.
  • Wood with knots, uneven, cross-grain or end-grain
  • Particle board, laminates, or other composites.
  • Boards without a flat surface on at least one side.

Use the Jointer to flatten one side before planing

  • Plastics, metals
  • Anything stupid.

Safety Notes

Headphones goggles.png
  • Wear safety goggles. Eyeglasses are NOT safety goggles.
  • This machine is LOUD. Wear hearing protection.
  • No loose clothing, neckties, rings, or other jewelry. Roll up sleeves. Wear shoes with good traction. Do not wear gloves.
  • Switch on the dust collector before feeding stock into the machine. It is a Coral AF/2C two-filter collector shared with the Powermatic 1696 Jointer.
  • Keep safety guards in place at all times when the machine is in use.
  • Do not push the workpiece into the machine.
  • Do not take a depth of cut greater than 1/16 inch. This is one full turn on the adjustment wheel.
  • If the machine is damaged, place a RED tag on it explaining the problem. Do not attempt to fix it yourself.
Beast red tag
Maintenance Request Tag.
  • Maintain a balanced stance at all times so that you do not fall or lean against moving parts. Do not overreach or use excessive force to perform any machine operation.
  • Do not feed stacked boards. They can kick back.
  • Do not plane a board with loose knots or with nails or any foreign material on its surface.
  • Twisted, warped, or wind-in stock should first be jointed on one surface before attempting to plane a parallel surface on the planer. Serious stock flaws cannot be removed by use of a planer alone.
  • Keep hands outside of the machine. Never reach under the guards to try to clear stock that has stopped feeding.
  • When starting a cut, do not have any part of the hands under that part of the board that is over the table; the infeed roller will engage the board and force it down against the table causing a pinching action.
  • Never leave the machine running unattended.
howit works
Cross-section of the machine.

To interpret the results of test cuts, see pp. 16-21 of the 201 Planer User Manual.