Sentry Kiln Tool Resource Page: Difference between revisions

From Artisans Asylum Wiki
No edit summary
No edit summary
Line 9: Line 9:
   |serial            = Froot Loops
   |serial            = Froot Loops
   |manufacturer_specs =  8x8x8 inches 1350 F max
   |manufacturer_specs =  8x8x8 inches 1350 F max
   |manual            = [https://www.dropbox.com/s/30k4snls68syisb/Sentry%20Kiln%20Manual.PDF?dl=0]   
   |manual            = [https://www.dropbox.com/s/30k4snls68syisb/Sentry%20Kiln%20Manual.PDF?dl=0 Sentry Kiln Manual]   
   |location          = Casting Shop
   |location          = Casting Shop
   |training          =   
   |training          =   
   |testing            = [https://www.artisansasylum.com/tool-testing Sign up here]
   |testing            = [https://calendly.com/jones-alethea/30min?back=1&month=2022-12 Sign up here]
   |tool_categories    = [[Category:Casting Shop]]
   |tool_categories    = [[Category:Casting Shop]]
  |rubric            = [ https://www.dropbox.com/scl/fi/fywzf5y6ufyyq6dgihb3b/kiln_quick_start.jpg?rlkey=cyt0cgq9ixo8q0dexhg4h0oi4&dl=0 Instructions ]
}}
}}



Revision as of 17:34, 1 December 2023


Sentry Kiln
Sentry Kiln
General Info
Make Sentry
Model This is a RED tool.
Serial Froot Loops
Specs 8x8x8 inches 1350 F max
Manual Sentry Kiln Manual
Asylum Info
Location Casting Shop
Rubric [ https://www.dropbox.com/scl/fi/fywzf5y6ufyyq6dgihb3b/kiln_quick_start.jpg?rlkey=cyt0cgq9ixo8q0dexhg4h0oi4&dl=0 Instructions ]
Training
Testing Sign up here
Restrictions {{{restrictions}}}


This is a RED tool. Reservation required

8" x 8" x 8" Sentry kiln for burning out lost-wax molds in the casting shop.  You must be tool-tested in the casting shop to use this tool.  Capacity: 4- 3"diameter x 4" height lost wax molds.  Typical max temperature is 1350 F.  Burnout of molds takes about 10 hours.  Molds can be burned out in advance and stored until you are ready to cast, then preheat molds to 900-1100 F.

You must run the shop ventilators and wear gloves and eye protection when using this tool.

Summary instructions for operation can be found here:

https://www.dropbox.com/scl/fi/fywzf5y6ufyyq6dgihb3b/kiln_quick_start.jpg?rlkey=cyt0cgq9ixo8q0dexhg4h0oi4&dl=0

A user manual for this tool can be found here:

https://www.dropbox.com/s/30k4snls68syisb/Sentry%20Kiln%20Manual.PDF?dl=0

Instructions can also be found in the lost-wax class handout here:

https://www.dropbox.com/scl/fi/fmu1skmdkiaeya27uhym4/Lost-Wax-Class-Handout.pdf?rlkey=m1sxqfcuze5khie3um1eit364&dl=0