Spot Welder Chicago 61206

From Artisans Asylum Wiki
Revision as of 11:45, 5 February 2024 by Jfbredt (talk | contribs)



Chicago Spot Welders
Spot Welder
General Info
Make Various
Model n/a
Serial Unknown
Specs n/a
Manual n/a
Asylum Info
Location Metal Shop
Rubric n/a
Training Tool classes
Testing Tool testing, or [[:Category:Metal Shop#Tool

Testing Night|come to the shop on Tool Testing Night]]

Restrictions green


Use for:

  • Sheet metal, including uncoated mild steel, galvanized steel, and stainless.
  • Mild Steel Capacity: up to 3/16” combined thickness.
  • Galvanized Steel Capacity: two pieces 16 ga (0.059”).

Do Not Use for:

  • Aluminum, copper or copper alloys.
  • Note that spot welds are weak, typically for ornamental applications.

Safety Hazards

height: 1.5em;"
Goggles.png

1. Sparks from the welding process. Eye Protection Required.

2. Electrocution, causing potential injury or death.

3. Burns from flame, sparks, hot workpieces. Wear protective clothing and shoes, leather gloves.

4. Poisoning from breathing gases produced by the welding process. Use proper ventilation. Do not stick head in fumes. Respirator recommended.

5. Keep workplace clear of flammable materials, including grease, oil, solvents, paper.

Operation Notes

height: 1.5em;"
50% duty.png
  • Avoid Electric Shock.
  • Never touch the Upper and Lower Tongs when unit plugged in.
  • Never touch Electrode Tips to grounded material when unit is plugged in.
  • Never expose unit to water or damp objects, especially during use.
  • Metal workpiece must be clean. Remove rust, scale, oxides, paint, grease, and oil.
  • Welder has a 50% duty cycle. Unit can weld for 5 seconds out of each 10 second time interval without overheating. Failure to observe duty cycle can destroy the welder.
  • 'Excessive Tong pressure can damage the Electrode Tips. Do not use the Tongs as a clamp or vise. Use separate clamps to hold workpieces together for good contact at the weld point.
  • The Electrode Tips deform during use and occasionally need dressing. For optimal weld quality, inspect Electrode Tips before use and clean, dress (resurface), or replace as needed for proper contact surface.
  • For successful welds, do not weld more than two pieces of metal at a time.
Warning Safety glasses Eye protection required!