Category:Bracketage: Difference between revisions
From Artisans Asylum Wiki
No edit summary |
No edit summary |
||
(9 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
Bracketage (rhymes with "garage") is the art of designing, making and installing brackets. Working mechanical engineers spend a significant amount of their careers designing ways to bracket objects onto each other. | |||
This page is intended to support that important though unglamorous subject. | |||
[[:Brackets_Tutorial_2b:_Fabricating_a_Bracket_from_a_Solidworks_Design | Tutorial 2b]] | Below is a set of tutorials showing basic use of Solidworks leading to sheet-metal bracket design and fabrication in the [[:Category:Metal Shop | Metal Shop]] | ||
{| class="wikitable" | |||
|+ Solidworks Tutorials | |||
|- | |||
! [[:Brackets_Tutorial_1:_Solidworks_From_Zero | Tutorial 1 ]] !![[:Brackets_Tutorial_2a:_Reverse-Engineering_a_Bracket_in_Solidworks | Tutorial 2a]] !! [[:Brackets_Tutorial_2b:_Fabricating_a_Bracket_from_a_Solidworks_Design | Tutorial 2b]] | |||
|- | |||
| Lowest-level introduction || Designing a bracket || Building the bracket | |||
|- | |||
| [[File:brick_with_hole_thumb.png|200px]] || [[File:bracket1_thumb.png|200px]] || [[File:bracket1_welded_thumb.png|200px]] | |||
|} |
Latest revision as of 20:36, 11 June 2024
Bracketage (rhymes with "garage") is the art of designing, making and installing brackets. Working mechanical engineers spend a significant amount of their careers designing ways to bracket objects onto each other.
This page is intended to support that important though unglamorous subject.
Below is a set of tutorials showing basic use of Solidworks leading to sheet-metal bracket design and fabrication in the Metal Shop
Tutorial 1 | Tutorial 2a | Tutorial 2b |
---|---|---|
Lowest-level introduction | Designing a bracket | Building the bracket |
Pages in category "Bracketage"
The following 3 pages are in this category, out of 3 total.