Hydraulic Shop Press: Difference between revisions
From Artisans Asylum Wiki
| Line 39: | Line 39: | ||
! colspan="2" class="infobox-image" | [[File:Metal_shop_press_bending_tool_longitudinal.png|200px|bender_longit]] | ! colspan="2" class="infobox-image" | [[File:Metal_shop_press_bending_tool_longitudinal.png|200px|bender_longit]] | ||
|- | |- | ||
| colspan="2" | | | colspan="2" | Longitudinal bending tool. | ||
|} | |} | ||
| Line 45: | Line 45: | ||
! colspan="2" class="infobox-image" | [[File:Metal_shop_press_bending_tool_transverse.png|200px|bender_transv]] | ! colspan="2" class="infobox-image" | [[File:Metal_shop_press_bending_tool_transverse.png|200px|bender_transv]] | ||
|- | |- | ||
| colspan="2" | | | colspan="2" | Transverse bending tool. | ||
|- | |- | ||
|} | |} | ||
Revision as of 19:56, 5 September 2024
Link to: Metal Shop main page
| 12-Ton Shop Press | |
|---|---|
| General Info | |
| Make | Duralast |
| Model | 12-ton |
| Serial | Unknown |
| Specs | n/a |
| Manual | n/a |
| Asylum Info | |
| Location | Metal Shop |
| Rubric | n/a |
| Training | Tool classes |
| Testing | Tool testing, or come to the shop on Tool Testing Night |
| Restrictions | green |
Description
This is a 12-ton hydraulic "bottle" jack mounted to a steel frame so it can be used as a press. The pressure relief valve is located on the press base. This machine is generally used for bending sheets and bars, and it usually has a 4" wide right-angle bending tool and die set mounted. The opening in the frame is 16" wide.
Use for:
- Bending steel sheets and bars up to 1/8" thick
Do not use for:
- High-carbon or Hardened steel
- Round or square stock
Safety Hazards
 |
 |
Eye protection required! |
|---|---|---|
- Workpiece can unexpectedly snap
- Pinching injuries
- Cuts/scrapes from sharp edges and burrs
Tooling
| |
|---|---|
| Removing the tool with a "dead-blow" hammer. |
| |
|---|---|
| Longitudinal bending tool. |
| |
|---|---|
| Transverse bending tool. |
