Hydraulic Shop Press: Difference between revisions

From Artisans Asylum Wiki
No edit summary
No edit summary
Line 5: Line 5:
Link to:  [[:Category:Metal Shop#Tools | Metal Shop tool list]]
Link to:  [[:Category:Metal Shop#Tools | Metal Shop tool list]]


This tool is used in [[:Brackets_Tutorial_2b:_Fabricating_a_Bracket_from_a_Solidworks_Design#Bend_the_Sheet | Brakets tutorial 2b.]]
This tool is used in [[:Brackets_Tutorial_2b:_Fabricating_a_Bracket_from_a_Solidworks_Design#Bend_the_Sheet | Brakets tutorial 2b]] and


{{ToolBox|tool_title=12-Ton Shop Press|image=SW_3_BracketRE_16_press.png|caption=Shop press for bending|location=Metal Shop|training=[https://www.artisansasylum.com/class-catalog Tool classes]|
{{ToolBox|tool_title=12-Ton Shop Press|image=SW_3_BracketRE_16_press.png|caption=Shop press for bending|location=Metal Shop|training=[https://www.artisansasylum.com/class-catalog Tool classes]|

Revision as of 22:18, 15 September 2024


Link to: Metal Shop main page

Link to: Metal Shop tool list

This tool is used in Brakets tutorial 2b and


12-Ton Shop Press
Shop press for bending
General Info
Make Duralast
Model 12-ton
Serial Unknown
Specs n/a
Manual n/a
Asylum Info
Location Metal Shop
Rubric n/a
Training Tool classes
Testing Tool testing, or come to the shop on Tool Testing Night
Restrictions green


Description

pressure_relief
Pressure relief

This is a 12-ton hydraulic "bottle" jack mounted to a steel frame so it can be used as a press. The pressure relief valve is located on the press base. This machine is generally used for bending sheets and bars, and it usually has a 4" wide right-angle bending tool and die set mounted. The opening in the frame is 16" wide.

Use for:

  • Bending steel sheets and bars up to 1/8" thick

Do not use for:

  • High-carbon or Hardened steel
  • Round or square stock

Safety Hazards

Warning Safety glasses Eye protection required!


  • Workpiece can unexpectedly snap
  • Pinching injuries
  • Cuts/scrapes from sharp edges and burrs

Bending

  • Mark your workpiece with a clearly visible line.
bending
Bend
squaring
Square
marking
Mark
  • Insert the workpiece into the jig and lower the workpiece so it lightly loads.
  • Square the workpiece in the tool.
  • Pump up the pressure to bend the workpiece.
  • Check the angle with a square as the bend approaches 90°. If you squeeze too far, the bend can surpass 90°.


Tooling

dead_blow
Removing the tool with a "dead-blow" hammer.
bender_longit
Longitudinal bending tool.
bender_transv
Transverse bending tool.

The bending tool is press-fit onto the ram below the bottle jack. It can be positioned at any angle, but the two most useful orientations are shown here: longitudinal and transverse.

To remove the tool, hit it with a "dead-blow" hammer with a soft head until it lossens up and comes off. Reposition, and press it onto the ram using the press.