Category:Plasma Shop: Difference between revisions
From Artisans Asylum Wiki
No edit summary |
No edit summary |
||
| Line 17: | Line 17: | ||
'''Description''' | '''Description''' | ||
The tool consists of a CNC gantry with a 48"x96" table that carries a Hypertherm "PowerMax85" plasma torch. Cuts are made vertically over a water tank. | |||
'''This is a [[RED]] tool''' Users must be trained and toll-tested before they are permitted to operate it. | '''This is a [[RED]] tool!''' Users must be trained and toll-tested before they are permitted to operate it. | ||
Materials qualified for general use are: '''Mild Steel, Stainless Steel, and Aluminum.''' Other materials that have been successfully tested are: Titanium and Brass. | |||
Driver software is called "Torchmate 4" located on the attached computer with several installations around the Asylum. | |||
Revision as of 14:13, 15 January 2024
| CNC Plasma Cutter | |
|---|---|
| CNC Plasma Cutter | |
| Building | {{{building}}} |
| Lead | Sam Feine |
| User email list | members@artisansasylum.com |
| Tool Testers |
Jim Bredt |
| Hours | Same as membership hours |
There is only one tool in this shop.
Torchmate CNC Plasma Cutter
Description
The tool consists of a CNC gantry with a 48"x96" table that carries a Hypertherm "PowerMax85" plasma torch. Cuts are made vertically over a water tank.
This is a RED tool! Users must be trained and toll-tested before they are permitted to operate it.
Materials qualified for general use are: Mild Steel, Stainless Steel, and Aluminum. Other materials that have been successfully tested are: Titanium and Brass.
Driver software is called "Torchmate 4" located on the attached computer with several installations around the Asylum.
Pages in category "Plasma Shop"
The following 2 pages are in this category, out of 2 total.
