Category:Plasma Shop: Difference between revisions
No edit summary |
No edit summary |
||
| Line 28: | Line 28: | ||
Artisans Asylum Antwerp Building, 55 Antwerp Street, Allston. Adjacent to the Metals Shop in the northeast corner of the building. | Artisans Asylum Antwerp Building, 55 Antwerp Street, Allston. Adjacent to the Metals Shop in the northeast corner of the building. | ||
== Safety == | |||
The power switch for the ventilator is located on the wall to the left of the drive computer, adjacent to the sheet metal rack. | |||
The emergency cutoff button (E-STOP) is located on the corner of the table nearest to the shop entry. | |||
A sink is located on the wall opposite the drive computer. | |||
A fire extinguisher is located adjacent to the sink. | |||
'''In the unlikely event of a flammable metal fire, DO NOT ATTEMPT TO EXTINGUISH. Call 9-1-1 and evacuate the area.''' | |||
Revision as of 14:45, 15 January 2024
| CNC Plasma Cutter | |
|---|---|
| CNC Plasma Cutter | |
| Building | {{{building}}} |
| Lead | Sam Feine |
| User email list | members@artisansasylum.com |
| Tool Testers |
Jim Bredt |
| Hours | Same as membership hours |
There is only one tool in this shop.
Torchmate CNC Plasma Cutter
Description:
The tool consists of a CNC gantry with a 48"x96" table that carries a Hypertherm PowerMax85 plasma torch. Cuts are made vertically over a water tank. Four levels of torch power are available so that mild steel sheets ranging from 0.018" (26-Ga) to 1.25" thick may be cut. Maximum cut speed is 350 in/minute.
This is a RED tool! Users must be trained and tool-tested before they are permitted to operate it.
Materials qualified for general use are: Mild Steel, Stainless Steel, and Aluminum. Other materials that have been successfully tested are: Titanium and Brass.
Driver software is called Torchmate 4 located on the attached computer with several installations around the Asylum. Input data is in the form of a 2-D sketch, either as G-Code (*.txt or *.fgc) or DXF (*.dxf).
Location:
Artisans Asylum Antwerp Building, 55 Antwerp Street, Allston. Adjacent to the Metals Shop in the northeast corner of the building.
Safety
The power switch for the ventilator is located on the wall to the left of the drive computer, adjacent to the sheet metal rack.
The emergency cutoff button (E-STOP) is located on the corner of the table nearest to the shop entry.
A sink is located on the wall opposite the drive computer.
A fire extinguisher is located adjacent to the sink.
In the unlikely event of a flammable metal fire, DO NOT ATTEMPT TO EXTINGUISH. Call 9-1-1 and evacuate the area.
