Flex Shaft Die Grinder
From Artisans Asylum Wiki
| Flex Shaft Die Grinder | |
|---|---|
| General Info | |
| Make | Foredom |
| Model | CC |
| Serial | Unknown |
| Specs | |
| Manual | |
| Asylum Info | |
| Location | Metal Shop |
| Rubric | |
| Training | Tool classes |
| Testing | Tool testing, or [[:Category:Metal Shop#Tool Testing
Night|come to the shop on Tool Testing Night]] |
| Restrictions | green |
Use for:
- The motor has a maximum speed rating of 18,000 RPM. Always use an accessory which has the same or a higher rating than your tool.
- This flexible shaft power tool tolerates up to 12 lbs. of torque.
- The CC Series is a general, all purpose motor.
- Hand Piece accepts any size shank up to 5/32” (4mm) diameter.
Do Not Use for:
- Consider another tool for heavy duty or industrial applications. Die grinders and air tools are heavy duty alternatives.
Hazard Analysis
| |
|---|---|
- Debris, chips, and sparks can become airborne during the use of this tool. Safety glasses or face shield required.
- Mask or respirator recommended to prevent inhalation of dust particles.
- No loose clothing, jewelry, neckties, etc. Tie back long hair. Loose items can cause injury when drawn in to the tool’s rotating parts.
- Never operate an accessory at speeds above the accessory’s rated maximum speed. Serious injury can result if an accessory breaks during use.
- This tool vibrates during use. Secure the motor to its hanger or work surface to prevent it from falling.
Operation Notes
- The Foredom Flex Shaft as four components:
- The Motor
- The Flex Shaft (with sheath covering and inner shaft)
- The Foot Pedal (for variable speed control).
- The Hand Piece (with three jaw chuck and key).
- Let the speed of the tool do the work. Do not apply heavy pressure to the accessory.
- Generally, slower speeds are used for rougher, heavier work, or when greater control over the accessory is required for precise, delicate work. Higher speeds are used for buffing, cutting and polishing.
- Always replace the dust cover when the tool is not in use. Metal dust entering the motor’s ventilation slots can shorten the tool’s life.
