Brackets Tutorial 2a: Reverse-Engineering a Bracket in Solidworks
From Artisans Asylum Wiki
Link to: Bracketage Main Page
Solidworks basic tutorial by Jim Bredt 20240606
This tutorial assumes basic experience with Solidworks.
If you are unsure how to use the basic tools in Solidworks, then step through the From Zero tutorial
When you load Solidworks you will see a dialog box like the one below.
Select "Part" to create a new design for a part.
Select "Extruded Boss/Base" in the "Features" tab. Select a plane to sketch on.
Change the drawing units to inches. Click on the (
) gear icon in the upper left corner of the window.
