Category:Bracketage
From Artisans Asylum Wiki
Bracketage (rhymes with "garage") is the art of designing, making and installing brackets. Working mechanical engineers spend a significant amount of their careers designing ways to bracket objects onto each other.
This page is intended to support that important though unglamorous subject.
Below is a set of tutorials showing basic use of Solidworks leading to sheet-metal bracket design and fabrication in the Metal Shop
| Tutorial 1 | Tutorial 2a | Tutorial 2b |
|---|---|---|
| Lowest-level introduction | Designing a bracket | Building the bracket |
 |
 |
|
Pages in category "Bracketage"
The following 7 pages are in this category, out of 7 total.
B
- Brackets Tutorial 1: Solidowrks From Zero
- Brackets Tutorial 1: Solidworks From Zero
- Brackets Tutorial 2a: Reverse-Engineering a Bracket in Solidworks
- Brackets Tutorial 2b: Fabricating a Bracket from a Solidworks Design
- Brackets Tutorial 3: No Frills Shelf Bracket
- Brackets Tutorial 4: Basic Cardboard Aided Design
