Dake Drill Press: Difference between revisions
No edit summary |
No edit summary |
||
(3 intermediate revisions by the same user not shown) | |||
Line 15: | Line 15: | ||
|training = | |training = | ||
|testing = | |testing = | ||
|restrictions = | |restrictions = green | ||
|tool_categories = [[:Category:Drill Presses|See the Drill Presses category for notes on using all Drill Presses]] | |tool_categories = [[:Category:Drill Presses|See the Drill Presses category for notes on using all Drill Presses]] | ||
}} | }} | ||
There is one unit in the [[Metal Shop]] and one unit in the [[Machine Shop]] | There is one unit in the [[Metal Shop]] and one unit in the [[:Category:Machine Shop|Machine Shop]] | ||
Link to: [[:Category:Metal Shop#Tools | Metal Shop tool list]] | |||
{{EyeWarning}} | {{EyeWarning}} |
Latest revision as of 21:10, 5 September 2024
Dake Drill Press | |
---|---|
General Info | |
Make | Dake |
Model | SB-32V |
Serial | Unknown |
Specs | |
Manual | Dake SB-32V manual |
Asylum Info | |
Location | Metal Shop and Machine Shop |
Rubric | |
Training | |
Testing | |
Restrictions | green |
See the Drill Presses category for notes on using all Drill Presses
There is one unit in the Metal Shop and one unit in the Machine Shop
Link to: Metal Shop tool list
Eye protection required! | ||
---|---|---|
The Dake drill press is reversible with variable speed control. |
To start
1. Disengage the E-STOP button (left, bottom)
2. Turn the switch (right,bottom) to the desired direction. Forward is 99% of the useful cases
3. The spindle speed can be adjusted with the small black knob top right.
To Stop
1. Turn the three-position switch (bottom, right) to OFF.
2. Alternatively, push the E-STOP button.
NOTE: The Dake speed control knob adjusts the speed over a moderate range. To make large changes to the spindle speed:
1. Unplug the drill press
2. Open the belt/pulley cover
3. Loosen the belt-tensioning lock handle on the right side just in front of the motor.
4. Check the table of belt and pulley configurations. In the Metal Shop a hardcopy of the table is attached to the speed control box. You can also look at p. 15 of the Dake SB-32V manual.
5. Reconfigure the belts as desired.
6. Tension the belts by pushing the motor back and tightening the lock handle.
The Dake drill press has a third idler pulley in the power train. |
7. The belt shouldn't be too tight. It should be possible to deflect the belt 1/2" by pressing with a finger.
8. Close the belt/pulley cover.
9. Plug the machine back in.