Brackets Tutorial 3: No Frills Shelf Bracket: Difference between revisions
From Artisans Asylum Wiki
| Line 17: | Line 17: | ||
[[File:Tut3_Bracket_nofrills_marking_the_blank.jpg|650px|left|marking]] | [[File:Tut3_Bracket_nofrills_marking_the_blank.jpg|650px|left|marking]] | ||
[[File:Tut3_Bracket_nofrills_setting_blank_in_IW.jpg|200px|right|bar_in_shear]] | [[File:Tut3_Bracket_nofrills_setting_blank_in_IW.jpg|200px|right|bar_in_shear]] | ||
[[File:SW_gear_icon_tiny.png| | [[File:SW_gear_icon_tiny.png|6px|center|thin strip]] | ||
Depress the foot pedal on the Ironworker to bring the shear blade down. | Depress the foot pedal on the Ironworker to bring the shear blade down. | ||
Revision as of 20:33, 15 September 2024
Link to: Bracketage Main Page
Introduction
This document shows a very simple process for making a right-angle shelf bracket. It uses mostly GREEN tools in the metal shop. The dimensions are 6" x 6" x 1-1/4" but the reader will see that these dimensions are arbitrary.
Cut the blank
We use 1-1/4" x 1/8" steel strip and cut it on the Ironworker. Mark the overall length of the bar and the line where it should be bent with a highly visible marker. Put dots where the mounting holes will go.
Turn on the power to the Ironworker so the blade rises to the top of its travel.
Insert the bar and line up the cut line with the blade of the Ironworker shear. Tigthen down the stock clamp.
Depress the foot pedal on the Ironworker to bring the shear blade down.
