Cyclone Sand Blaster
Link to: Metal Shop main page
| Sand Blaster | |
|---|---|
| General Info | |
| Make | Cyclone Manufacturing |
| Model | DW-7335 |
| Serial | Unknown |
| Specs | |
| Manual | |
| Asylum Info | |
| Location | Metal Shop |
| Rubric | |
| Training | Tool classes |
| Testing | Tool testing, or [[:Category:Metal Shop#Tool Testing
Night|come to the shop on Tool Testing Night]] |
| Restrictions | green |
| |
|---|---|
| |
|---|---|
| |
|---|---|
 |
 |
Eye protection required! |
|---|---|---|
Description
A sand blaster is a machine that mixes abrasive grains with a jet of compressed air and allows the user to abrade the surface of a part, usually metal. This results in a clean though roughened part free of paint, rust, and other forms of dirt. For smaller parts the blast gun is contained in a glovebox cabinet sealed off from the outside. The user manipulates the tool with thick rubber gloves that pass through the wall of the cabinet.
The sand blaster cabinet at Artisans Asylum is located in a small room within the Metal Shop on the south wall adjacent to the enclosed loading dock.
Use For
- Steel
- Stainless Steel
- Zinc-coated steel (Galvanized)
- Aluminum, Titanium, Brass
- Painted metal
- Lightly Rusted Parts
Do Not Use For
- Lead-based paints
- Greasy or Oily Parts
- Massively Rusty Parts
Use a lead-test swab to verify that paint if NOT lead-based!
If the sandblaster becomes contaminated with lead the media must be disposed as TOXIC WASTE and the cabinet must be thoroughly cleaned out!
