General Hydraulic Shop Press
From Artisans Asylum Wiki
Link to: Machine Shop Main Page
| Hydraulic Shop Press | |
|---|---|
| General Info | |
| Make | General Hydraulic |
| Model | 20-ton |
| Serial | |
| Specs | |
| Manual | Pittsburgh 20-ton Bottle Jack Manual |
| Asylum Info | |
| Location | Machine Shop |
| Rubric | N/A |
| Training | |
| Testing | Tool testing |
| Restrictions | green |
Description
A hydraulic jack mounted to a frame that translates the lifting force into pressure. Built around a Pittsburgh 20-ton bottle jack. Width: 18 inches. Also includes a jig for bending metal sheet. It has a compressed-air actuator built in but can also be operated manually.
Use For
Squashing things
Do Not Use For
Not squashing things
Bending Accessory
| |
|---|---|
| The bending jig for the 20-ton shop press |
This accessory normally rests on the floor behind the press. Caution! Weight is about 60 lbs.
It is constructed over a piece of 3½" x 3½" x 5/16" angle, so the bends it makes are distributed through about 4" of length. To tighten up the bend radius, stack pieces of smaller angle inside the large one
