3DFabLight
From Artisans Asylum Wiki
Link to: Metal Shop main page
Link to: Metal Shop tool list
| 3D FabLight 3000 Watt sheetmetal cutting LASER | |
|---|---|
 | |
| General Info | |
| Make | 3D FabLight |
| Model | 3,000 Watt |
| Serial | {{{serial}}} |
| Specs | {{{manufacturer_specs}}} |
| Manual | Operation Manual |
| Asylum Info | |
| Location | Metal Shop |
| Rubric | {{{rubric}}} |
| Training | {{{training}}} |
| Testing | {{{testing}}} |
| Restrictions | red |
{{{tool_categories}}}
Description
THIS TOOL IS READY FOR LIMITED TESTING USE AT THIS TIME.
This tool uses a LASER and air pressure to cut thin sheets of metal
Use for:
- Steel (CRS): 0.15" (3.8mm) 9ga.
- Stainless steel: 0.125" 2.3mm 11ga.
- Aluminum: 0.083" (2.11mm) 12ga.
- Copper: 0.048" (1.22mm) 18ga.
Do Not Use for:
- Any sheet metal exceeding the maximum thickness for the type of metal.
- ANY NON METAL MATERIALS.
Hazard Analysis
- Materials can catch on fire while being cut.
- Coated metals will produce toxic gasses while being cut.
- Cuts/scrapes from sharp cut edges of work.
- Parts wil be hot after cutting. Burning hands may result when removing parts.
Operation Notes
- This machine requires fume extraction. Make sure both AC line cords are plugged in.
- This machine requires shop air. Instructions for starting and stopping the Antwerp Shop Air
- The blue Miller fume extraction unit will be started and stopped by the Fablight automatically. If you don't hear it when a cut starts, check the ON/OFF switch on the blue unit to the right-side of the Fablight and check that the second AC line cord is plugged in.
Basic Operation Instructions
FabCreator executable download
