Category:Computer Aided Design: Difference between revisions
From Artisans Asylum Wiki
No edit summary |
No edit summary |
||
| Line 9: | Line 9: | ||
|+ Solidworks Tutorials | |+ Solidworks Tutorials | ||
|- | |- | ||
! [[SolidWorks Tutorial | ! [[SolidWorks Tutorial 0: The SolidWorks User Interface | SolidWorks User Interface]] | ||
!! [[SolidWorks Tutorial 1a: Design of a 3D Printed Electronic Box | | !! [[SolidWorks Tutorial 1a: Design of a 3D Printed Electronic Box | Tutorial SW-1a: 3DP E-Box tutorial]] | ||
!! [[:Brackets_Tutorial_2b:_Fabricating_a_Bracket_from_a_Solidworks_Design | Tutorial 2b]] | !! [[:Brackets_Tutorial_2b:_Fabricating_a_Bracket_from_a_Solidworks_Design | Tutorial 2b]] | ||
|- | |- | ||
Revision as of 19:52, 4 May 2025
Below is a set of tutorials showing basic use of CAD software available on the computers in the Design/Photo Shop
| SolidWorks User Interface | ! Tutorial SW-1a: 3DP E-Box tutorial | ! Tutorial 2b |
|---|---|---|
| Beginner's Introduction | Designing a Bracket | Building the Bracket |
 |
 |
|
Pages in category "Computer Aided Design"
The following 17 pages are in this category, out of 17 total.
B
F
- FreeCAD Tutorial 0: The FreeCAD User Interface
- FreeCAD Tutorial 1a: Design of a 3D Printed Electronic Box
- FreeCAD Tutorial 1b: Design of an Electronic Box, Continued
- FreeCAD Tutorial 1c: Design of an Electronic Box, Continued
- FreeCAD Tutorial 1d: Design of an Electronic Box, Concluded
- Fusion Tutorial 1a: Design of a 3D Printed Electronic Box
- Fusion Tutorial 1b: Design of an Electronic Box, Continued
- Fusion Tutorial 1c: Design of an Electronic Box, Continued
- Fusion Tutorial 1d: Design of an Electronic Box, Continued
S
- SolidWorks Tutorial 0: The SolidWorks User Interface
- SolidWorks Tutorial 1a: Design of a 3D Printed Electronic Box
- SolidWorks Tutorial 1b: Design of an Electronic Box, Continued
- SolidWorks Tutorial 1c: Design of an Electronic Box, Continued
- SolidWorks Tutorial 1d: Design of an Electronic Box, Continued
