Category:Computer Aided Design: Difference between revisions

Revision as of 20:01, 4 May 2025

Below is a set of tutorials showing basic use of CAD software available on the computers in the Design/Photo Shop

Solidworks Tutorials
Tut SW 0 : SW UI	! Tut SW-1a: 3DP E-Box tutorial	! Tutorial 2b
User Interface Review	Simple Box Design	Building the Bracket

The following 17 pages are in this category, out of 17 total.

@@ Line 9: / Line 9: @@
 |+ Solidworks Tutorials
 |-
-! [[SolidWorks Tutorial 0: The SolidWorks User Interface | SolidWorks User Interface]]
+! [[SolidWorks Tutorial 0: The SolidWorks User Interface | Tut SW 0 : SW UI]]
-!! [[SolidWorks Tutorial 1a: Design of a 3D Printed Electronic Box | Tutorial SW-1a: 3DP E-Box tutorial]]
+!! [[SolidWorks Tutorial 1a: Design of a 3D Printed Electronic Box | Tut SW-1a: 3DP E-Box tutorial]]
 !! [[:Brackets_Tutorial_2b:_Fabricating_a_Bracket_from_a_Solidworks_Design | Tutorial 2b]]
 |-
-| Beginner's Introduction || Designing a Bracket || Building the Bracket
+| User Interface Review || Simple Box Design || Building the Bracket
 |-
-| [[File:brick_with_hole_thumb.png|200px]] || [[File:bracket1_thumb.png|200px]] || [[File:bracket1_welded_thumb.png|200px]]
+| [[File:tutorial_sw_0_thumbnail.jpg|200px]] || [[File:bracket1_thumb.png|200px]] || [[File:bracket1_welded_thumb.png|200px]]
 |}