Bridgeport Series 1 Standard Knee Mill

Bridgeport Series 1 Standard Knee Mill
Bridgeport
General Info
Make	Bridgeport
Model	Series 1
Serial	J292372
Specs	specs
Manual	{{{manual}}}
Asylum Info
Location	Machine Shop
Rubric	{{{rubric}}}
Training	Tool classes
Testing	Tool testing
Restrictions	red

Link to: Machine Shop Main Page

Safety Information

		Eye protection required!

Operating Instructions

Calibration 

To account for the error caused by inconsistent collet seating in the spindle, it is recommended to check the calibration of the Pro Tram Gage every time it is used. Completing the steps below will position the two indicator tips on a theoretical line that is perpendicular to the spindles axis.

• Install the Pro Tram into spindle.
• Place calibration magnet on the table under one of the indicators.
• Lower spindle until indicator is depressed about 0.100”. Then lock the spindle in place. Be sure to lock the knee of the mill as well.
• Rotate the face of the indicator until the needle reads zero. Then rotate the Pro Tram unit 180 degrees so that the other indicator is contacting the calibration magnet.
• Rotate the face of the second indicator until the needle reads zero.  
• After calibration the right and left indicator faces may be rotated to slightly different positions. This is caused by a slight variance in indicator length and will not affect the functionality of the unit.

Operation

• Install the Pro Tram into the spindle. Lock the knee of the mill.
• Position the Pro Tram parallel to the length of the milling machine table. Then lower the spindle until both indicators are depressed by about 0.050”.
• Make adjustments to the head of the milling machine until both indicators read the same number. When this is accomplished the first axis of the milling machine is trammed.
• Position the Pro Tram perpendicular to the length of the milling machine table. Then lower the spindle until both indicators are depressed by about 0.050”.
• Make adjustments to the head of the milling machine until both indicators read the same number. When this is accomplished the second axis of the mill is trammed.

	Caution When installing or removing the Pro Tram from the spindle keep at least one hand on the unit while tightening or loosening the draw bar. This will prevent the unit from accidently falling out of the spindle. If necessary put the machine in low gear to eliminate the need to hold the machine brake lever while tightening or loosening the draw bar.