|
|
|
| Startup Checklist
|
Shutdown Checklist
|
- Is the bed clean of debris?
- Use the shop vac to clean it, if necessary.
- Check that these items are where they're supposed to be:
- Water spray
- Fire blanket
- Fire extinguisher
- Turn the vent in.
- The vent switch is on the wall.
- Turn on the machine.
- Twist the E-stop button to power on.
- Is the chiller on?
- Check for the green light on the chiller.
- Is the air compressor on?
- Check for vibration from the air compressor.
- Are the mirrors clean?
- Visually inspect the X and Y axis mirrors. Clean with lens wipes if dusty or dirty.
- Is the lens clean?
- Look through the X Axis mirror to view the amber lens. If it looks dirty, clean the lens.
- Add materials and hold down (if needed).
- Focus the laser.
- Set origin.
- Send a job to the laser from Lightburn.
|
- Remove materials.
- Clean the bed.
- Shutdown the machine.
- Turn off the vent, as long as no other machines are in use.
- Clean up the shop.
|
| Fire Safety
|
- Flame right where the laser is cutting is ok.
- Flame anywhere else is a problem.
- Hit Pause.
- Move the laser head away from the flame.
- Open the machine.
- Spray the flame with water.
- If needed, use the fire blanket.
- If needed, use the fire extinguisher.
- The large one by the lasers is electronics safe. Use the whole thing at once; don’t be shy!
- The second fire extinguisher is by the door, and is also safe for electronics.
- Report any and all fires to staff and digifabshop@artisansasylum.com.
|
Do not leave the laser unattended while running.
Scan this code to view the lasercutter operator's manual.
Need a refresher?
Scan for the Operator’s Manual →
Want to cut a material that’s not in the Lightburn Materials Library? Email the MSDS to the shop leads for approval (digifabshop@artisansasylum.com).
Any questions? Email digifabshop@artisansasylum.com
